The way to Get a Homelite Model 330 Chain Saw Running
Even if your chain saw is an older model like the Homelite 330, with proper maintenance and care, it can nevertheless serve you for several decades. When you encounter an issue that stops your chain saw from starting, however, you might be tempted to invest in a brand new version. Rather than giving up too soon, troubleshoot your chain saw and take action to get it up and running.
Fuel and Oil Problems
When your Homelite 330 will not start, investigate issues that could be related to fuel and oil. To be able to run correctly, the chain saw must be filled with the right mixture of fuel and oil. Utilize a 50-to-1 ratio of unleaded gasoline and 2-cycle oil to power the machine. If the fuel was in the machine for a long period or is an improper mix, replace it with the appropriate mixture of fresh fuel and 2-cycle oil. Homelite advises combining small quantities of fuel and oil that can be used within a 30-day period for the very best outcomes.
Pull Cord Problems
Starter pull wires are vulnerable to problems that could make it difficult or impossible to start the saw. When the string is loose, cracked or torn, replace it or repair it. Since the starter unit is attached to the side of the chain saw and just a couple screws hold it in position, remove it for the repair procedure. You can also obtain other replacement components for the starter unit, like the spring and pulley. Use caution when removing the screw in the center of the recoil unit in case it retains tension that results in the pull string to recoil.
Clogged Filter Foibles
The Homelite chain saw has two filters that could cause starting problems. A clogged or dirty air filter might prevent sufficient air from reaching the motor, rendering it useless. Remove the air filter and clean or replace it. Clean the vents that surround it as well, especially if they are clogged with debris from your last cutting job. When you suspect the fuel filter is actually the issue, remove it from the gas tank by gradually lifting the gas line to which it’s attached from the gas tank, pop the filter off and replace it with a brand new one.
Spark Plug Concerns
When you try to start the chain saw and there’s no spark, the spark plug could be dirty or need replacement. When the spark plug is visibly dirty, remove it and then clean it with a wire brush. If there’s still no spark after cleaning, replace the spark plug with a brand new one. A improper gap in the spark plug might be an additional issue. Homelite recommends replacing the spark plug with an specific replacement after each 50 hours of use and setting the gap in .025 inch.
