How to eliminate Coins Stuck Inside a Front-Load Washer
If draining problems with your own front-loading washing machine coincide with an unexpected absence of change, the coins you’re missing are probably stuck at the washer’s drainage pump. They may not have even made it that way — they might be stuck at the drain filter or coin snare. Wherever they are, they are just the correct size to block the washer drain. Washing machine manufacturers usually design their products to create coins simple to eliminate; the procedure involves minimal disassembly, and also you might need to take out the drainage pump, that can be simpler to do than it sounds.
Unplug the washer to avoid getting a shock at the same time you start looking for the coins.
Start looking for a coin trap panel. If your washer has a coin trap, you will observe a small, square panel near the floor on the front or side of the device. Open the door and take out the trap by turning it counterclockwise and pulling. The contents of this snare may shock you. Remove them.
Find the drain pump by referring to this operator’s manual to your machine, on the manufacturer’s website, should youn’t see a coin snare. It is often close to the front of the machine, at the bottom, but it might also be near the rear, depending on the version. If it’s at the front, you must remove the front panel to access it. If it’s at the rear, you must remove the rear panel.
Remove the front access panel of the drier. On some versions, this panel covers the whole front of this machine in the bottom of the door into the floor, and you can pull it off or unscrew the screws holding it with a screwdriver. On newer machines, you must get rid of the door seal, disconnect the electric connection to the doorway and get rid of the detergent tray and control panel in order to gain access to the screws. Unscrew them to take out the panel.
Move the machine away from the wall to eliminate the rear panel in the event the pump is at the rear of the machine. Unscrew the screws holding the panel with a screwdriver and lift the panel off. You might need to disconnect the drain hose in order to eliminate the panel. If your pump sits at the front of the machine, then skip to Step 6.
Disconnect the electrical connector into the pump by pulling it out; eliminate the 2 hoses connected to the pump by squeezing the clamps holding them with pliers and pulling them off. Have an empty bucket ready to capture water.
Unhook the pump in the machine. You might be able to do that by pushing a tab, or you might need to unscrew one or two screws. Remove the pump and flip it over. Any coins stuck indoors should drop out. If you’re able to see coins within, but they do not come out, pry them out with a bit of stiff wire. A straightened-out clothes hanger works best, since you are able to bend it as required to attain the coins.
Shake the drain hoses to make sure no coins are stuck indoors. If there is one, it must drop out.
Replace the pump and hoses and push the electric connector back into its socket. Replace the front or rear access panel, reversing the procedure you used to carry it off. Slide the machine back into the outlet.
